Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 692 / 1956

PAGE 18
Feb 28/07 30-10-00
3J4
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
(d) Application in Combination.
AgeMaster® No. 1, ShineMaster® and Icex® II are specifically designed to use together
to provide maximum deicer care, appearance and performance.
1 Clean deicer surface to remove previous coatings, dirt, grease, oil and other
contamination. ShineMaster® Prep cleaner should be used to remove ShineMaster®
treatment.
2 Apply AgeMaster® No. 1, see above, and let dry at least 24 hours.
3 Apply ShineMaster® cosmetic treatment, see above, and let dry to touch.
4 Apply Icex® II, see above.
5 Icex® II may be removed with alcohol or warm, soapy water, then reapplied without
affecting ShineMaster® cosmetic treatment.
6 Icex® II and/or ShineMaster® cosmetic treatment can be removed without affecting
AgeMaster® No. 1.
7 Icex® II and/or ShineMaster® cosmetic treatment must be removed before
reapplying AgeMaster® No. 1.
E. Repair Limits.
CAUTION: PNEUMATIC DEICERS MUST BE REPLACED IF: (1) CUTS, TEARS OR RUPTURES
CUT THE INFLATABLE TUBE FABRIC AND/OR EXCEED 4 X 9 INCHES; OR, (2)
BROKEN STITCHES OR THREADS ARE APPARENT; OR, (3) DAMAGE LEAKS AIR
AND EXCEEDS THE PATCH AND PINHOLE REPAIR LIMITS SPECIFIED BELOW.
NOTE: In addition to meeting these repair limits, the deicer must also pass the Inspection
(Pneumatic Deicers (Boots)), Procedure, below.
NOTE: If patches and pinhole repairs are mixed within any 12 inch square, a ratio equivalent to the
repair limits should be followed. For example, in a 12 inch square it would be permissible to
have one (1) small patch (33% of repair limit) and 13 pinhole repairs (67% of repair limit).
The net effect is equivalent to 100% of the repair limits.
To maintain optimal functional efficiency of the deicers:
(1) The following patch limits are established:
(a) Three (3) small patches per 12 inch square (Small patch is 2-1/2" X 1-1/4"); or,
(b) Two (2) medium patches per 12 inch square (Medium patch is 5" X 2-1/2"); or,
(c) One (1) large patch per 12 inch square (Large patch is 5" X 10"); or,
(d) Two (2) small patches and one (1) medium patch per 12 inch square.
(2) No more than 20 pinhole repairs are allowed per 12 inch square.