Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 995 / 1956

PAGE 1
Feb 28/07 5F5
34-50-00
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
DEPENDENT POSITION DETERMINING
1. COM/NAV/GPS (GNS 430/530)
WARNING: FAILURE TO CONSULT APPLICABLE VENDOR PUBLICATION(S), WHEN SERVICING
OR INSPECTING VENDOR EQUIPMENT INSTALLED IN PIPER AIRCRAFT, MAY
RENDER THE AIRCRAFT UNAIRWORTHY. (SEE INTRODUCTION - SUPPLEMENTARY
PUBLICATIONS.)
A. Maintenance
Dual Garmin GNS-430 or Dual Garmin GNS-530 COM/NAV/GPS systems are installed as standard
equipment. Each installation consists of the GNS-430 or GNS-530 transceiver/display units,
associated wiring, and antennas.
Maintenance of the GNS-430 is “on condition” only and, with the exception of swapping complete
units, should be performed only by a qualified avionics shop in accordance with the GARMIN Series
400 Maintenance Manual (Garmin P/N - 190-00140-05).
Maintenance of the GNS-530 is “on condition” only and, with the exception of swapping complete
units, should be performed only by a qualified avionics shop in accordance with the GARMIN Series
500 Maintenance Manual (Garmin P/N - 190-00181-05).
Information provided in this manual is intended solely to aid the removal and installation of the
GNS-430/530 transceiver/display units, their associated wiring and antennas.
B. Removal and Installation
See 39-10-00.
C. Post-Installation Lighting Set-up
See 33-10-00, Post-Installation Lighting Set-up.
D. Post Installation Setup Procedure
(PIR-PPS 60199, Rev. New., PIR-PPS 60199-2, Rev. I.)
(1) Aircraft Preparation and Configuration
Setup and preliminary checks may be made using the aircraft battery or external power
supplied by an external power cart. Final checks (OBS/CDI or HSI accuracy) should be made
with the engine running and the aircraft configured as in Chart 1.
(2) Configuration Setup Procedure
Access the Configuration Mode of the unit by depressing and holding the ENT key while
applying power to the unit. Release the ENT key when the display activates. After the data
base pages, press the ENT key twice to display the MAIN ARINC 429 CONFIG page. Pages
may be selected by ensuring the cursor is off and rotating the inner concentric knob on the
right side of the unit.
Engine running, alternators On
Instrument Panel Lights Full Bright
Navigation Lights On
Pitot Heat Off
Cabin Blower Fan Low
Avionics On
Day/Night Switch Day
Strobe Lights On
Air Conditioning Off
Vent Blower Off
CHART 1
FINAL CHECK CONFIGURATION