Piper Aircraft Corporation Malibu Mirage PA-46-350P, Airplane Maintenance Manual

Page: 691 / 1956

PAGE 17
Feb 28/07
30-10-00
3J3
PIPER AIRCRAFT, INC.
PA-46-350P, MALIBU MIRAGE
MAINTENANCE MANUAL
4 Repeat Step 3, above, so that three even coats have been applied with 5-10 minutes
dry time between each coat.
5 Let dry 24 hours before flying aircraft or applying Icex® II or ShineMaster® products.
(b) ShineMaster® Application.
ShineMaster® treatment is a cosmetic coating that provides high luster shine.
ShineMaster® Prep cleaner is used to clean deicer for ShineMaster® application, and
remove residual ShineMaster® before reapplication. Application interval for ShineMaster®
depends on operating environment (2 or 3 times per year is typical).
NOTE: ShineMaster® products can be applied to deicers that have been repaired with
Goodrich P/N 74-451-AA patch kit and/or Goodrich P/N 74-451-AE pinhole repair
kit.
NOTE: ShineMaster® cosmetic treatment should not be heavily applied or allowed to
build-up on deicer edges, as it may appear cracked and is very difficult to remove
when reapplication is desired.
1 Clean deicer surface with ShineMaster® Prep cleaner to remove dirt, grease, oil,
silicone products and other contamination. Previous applications of ShineMaster®
treatment must be removed before reapplication to avoid dulling or product build-up.
2 Apply light, even coat of ShineMaster® cosmetic treatment to deicer with clean lint-
free cloth wiping in one direction. Let dry to touch - about 5-15 minutes.
3 Repeat Step 2, above, once or twice to obtain desired shine.
(c) Icex® II Application.
Icex® II is an ice adhesion inhibitor that enhances deicer performance by lowering
adhesion strength between ice and deicer surface. During icing season, apply Icex® II
every 50 flight hours.
NOTE: Icex® II is not a cure-all for icing problems. Icex® will not prevent or remove ice
formations. Its only function is to keep ice from initially getting a strong foothold,
thus making removal easier.
NOTE: Icex® II can be applied to deicers that have been repaired with Goodrich P/N 74-
451-AA patch kit and/or Goodrich P/N 74-451-AE pinhole repair kit.
NOTE: If Icex® II is applied too heavily, result can be sticky surface that collects dust and
dirt, reducing efficiency of Icex® II. Residue should be completely removed
before reapplication.
1 Clean deicer surface using mild soap and water.
2 Rinse with clean water and let dry.
3 Clean with isopropyl alcohol to remove substances not removed with soap and
water.
4 Repeat Steps 1 and 2, above.
5 Apply Icex® II with clean cloth or pad. Apply lightly and wipe in single continuous
back and forth motion spanwise on deicer.