Pima Hunter-Pro 8144, Installation Manual

Page: 63 / 116

Programming the System 63
Hunter-Pro Series & Captain 8 Installation Guide
The following table lists the output types that have timers and their default times.
Output type Time (sec.)
Ext. Siren triggered 240
Int. Siren triggered 240
Burglary alarm 240
Anti Mask alarm 240
Special Burglary 1 alarm 240
Special Burglary 2 alarm 240
Smoke alarm 240
Fire alarm 240
Special Fire alarm 240
Panic alarm 240
Silent Panic alarm 240
Hold Up alarm 240
Medical alarm 240
Tamper alarm 240
Mains Fault 9999
Low Battery 9999
Phone Failure 9999
Zone Tamper 9999
Zone Bypass 9999
GSM Fault 9999
Communication Fault 9999
Tag Activation 240
Door code entered 5
Wireless Remote 5
Test executed 5
Audio Device triggered 60
Remote control* 60
Zone Open Hold T** 0 (min.)
* This output type is triggered when a physical output is activated by telephone.
** This output type is triggered when the alarm system is disarmed and the last open zone is
closed. When count down expires the assigned physical output can be used for energy
saving - turning off the lights, for example.
6.7.3 AC report delay
Set a time (in minutes, max. 250) to delay AC fault reports. The default is 15 min.
6.7.4 Phone report delay
Set a time (in minutes) to delay reporting on telephone line faults. Note that if the parameter
“No Dia. tone chck” (see section ‎6.5.4, on page 59) is disabled, this parameter is negligible.
If the telephone line is usually clear, do not set a delay time.
6.7.5 Burglary report delay
Set a time in seconds (default is zero) to delay reporting on violation of 24-hour zones, if
occurred during the entry delay. The sirens will onetheless sound the alarm. This delay is valid
to all the burglary alarm types. If the panel is disarmed before coundown expires, the event
will not be reported.