Pima Hunter-Pro 8144, Installation Manual

Page: 57 / 116

Programming the System 57
Hunter-Pro Series & Captain 8 Installation Guide
6.5.6 GSM Transmitter
The following menus are displayed only if the “Enhanced Menu” is enabled. See
parameter "P" in section ‎ 6.8.1, on page 65 for details.
Set the GSM-200 cellular communicator's parameters
1
.
6.5.6.1 GSM Settings
Char. Parameter When setting to “+”…
G GSM TX Installed The GSM-200 communicator is connected
R Use Radio ID Account The radio acount ID will be used for the GSM-200 reports
T Auto Test Report Test reports will be sent via the GSM-200, in addition to
PSTN reports.
Y GPRS Encryption Reports sent via the GSM-200 will be encrypted and sent
via the GPRS channel
S SMS Backup The SMS channel will serve as a backup channel to the
GSM-200:
“+”: via SMS messages;
“-”: via the Voice channel.
6.5.6.2 GSM Modes
The GSM-200 has 2 operation modes, that can be used for reporting to two Monitoring
Stations: Mode #1 for Monitoring Station #1, and Mode #2 for Monitoring Station #2. Each
mode has 3 optional channels: Voice, GPRS or SMS
2 .
To set Mode #2 channel, press [ENTR] in the selected Channel screen.
If both Monitoring Stations use the GPRS channel, Mode #2 will be used to report to
Monitoring Station #2.
The DATA channel is not in use; make sure not to select it.
6.5.6.3 GSM Phones
Set the Monitoring Station's up to 4 GSM phone numbers. If “Split account number” is enabled
(see section ‎6.5.4, on page 54), phone numbers #1 & #2 will be used for Monitoring Station #1,
phone numbers #3 & #4 will be used for Monitoring Station #2.
6.5.6.4 GPRS Settings
Set the GPRS settings: the Monitoring station's IP no., port number and GPRS test interval.

GSM-200 Version 1.13 supports SMS reports and does not support remote upload
via the GPRS; version 1.14 supports remote upload via the GPRS channel but
does not support SMS reports. Versions 1.15 and up support both.

To access the GSM-200 using a URL, the address should be set in the net4pro.

To display the GSM-200 version (or the SMS-100, if installed), press [ENTR] for 2
seconds in the main screen.

The GSM-200 and the SMS-100 modules cannot be connected together.
1
To display the GSM-200 version (and the SMS-100 one), press [ENTR] for 2 seconds.
2
The DATA channel is not in use currently.