Pima Hunter-Pro 8144, Installation Manual

Page: 56 / 116

56 Programming the System
Hunter-Pro Series & Captain 8 Installation Guide
6.5.5 Report codes 4X2
6.5.5.1 Zones, Zones Restore and General Reports
Set the zone's 4X2 reporting codes. The codes are in hex (0-9, A-F). The Restore codes are
displayed as “RX”. The default ContactID

, PAF and NPAF code for all zones is “FF”. To report
with different ContactID  codes, use the following steps:
a. Subtract 100 from the desired ContactID event number; e.g., “High Temperature”
has the event number of 158; 158 less 100 is 58.
b. Convert the result to hex number. In this example the event will be 3A.
Press [NEXT] to advance, [BACK] to move back, [*] to enter letters, [ENTR] to save and
proceed to the next zones.
When using ContactID

the Alarm and Restore codes must be the same
The PSTN 4x2 report codes menu and the following radio menu have 3 sub-menus: Zones,
Zones restore and General Reports. The codes are described in the following table.
Restore cods are displayed as “RESTR” to the event’s right.
Code Description
Z1, Z2, Z3… Zone alarms
R1, R2, R3… Restore codes. Restore events are sent at the siren cut-off, or if
disarming occurs immediately after alarm.
ZFL + RESTR Zone fault in EOL supervised zone + Restore code
BYP Zone bypassed
TM1, TM2 +
RESTR
TMPR 1/TMPR 2 Restore code
AC + RESTR AC fault + Restore code
LB + RESTR Low b Restore code
PF + RESTR Power failure: PCB voltage lower than 9V + Restore code
PHN + RESTR Phone line fault + Restore code
PNC Panic code
ICODE Invalid code: max. no. of keystrokes exceeded (see section ‎6.7.10, on
page 64)
FUS + RESTR Fail-unsafe: detectors' voltage fault + Restore code
ARM The system was armed
DISAR The system was disarmed
TST System test (manually, automatically, or on “wake-up”).