Pima Hunter-Pro 8144, Installation Manual

Page: 14 / 116

14 HUNTER-PRO Series
Hunter-Pro Series & Captain 8 Installation Guide
3.1 Connecting zones

The overall length of the BUS wires cannot exceed 500 meters. If a longer
distance is required, refer to section
‎
3.2.1, on page 15.

The BUS implements PIMA proprietary protocol.
IMPORTANT! Disconnect all power supply prior to installation!
3.1.1 Common zone wiring
Diagram 4. Zone wiring options
The zone state - Normally Open or Normally Close - is set in the “Zone characteristics” screen;
see section ‎6.4.1.1, on page 50.
3.1.2 EOL resistor loops
To set a zone with one or two EOL resistor loops, refer to “Zone characteristics” screen,
parameter “E” (see section ‎6.4.1.1, on page 50) and “
Key 5
: General Parameters”, first
screen, parameter "2" (see section ‎6.8, on page 65).
3.2 Zone expanders wiring
The following is a brief scan of the zone and output expansion options. A detailed installation
description is found further on.
Expander Description
EXP-PRO
UNIV
Local 8 zone expansion card. The zones are always given the numbers 9-16.
See more on section ‎3.2.4.
The expansion card is connected to the PCB’s “Expansion Card” connector.
I/O-8N Remote 8 zone expander with an onboard relay;
It is connected to the panel over the BUS wires.
I/O-16 Remote 16 zone expander with an onboard relay;
It is connected to the panel over the BUS wires.
I/O-WN 24 (in Hunter-Pro 832)/32 (in Hunter-Pro 8144) zone wireless expander.
It also supports 24 key fobs.
I/O-R Remote 8 relay expander; see more on page 20.
Z1 Z2 Z3 Z4 Z5 (-)
N.O./N.C.,
2 EOL
Resistors
N.O.,
1 EOL
Resistor
N.C.,
1 EOL
Resistors
N.O. N.C.
A A A A A
T T T T
T: Tamper
A: Alarm
R2 R1 R1 R1