Phytec phyCORE-i.MX 6, Hardware Manual

Page: 32 / 82

phyCORE
®
-i.MX 6 [PCM-058]
18 ©
PHYTEC Messtechnik GmbH 2016 L-808e_2
3 Jumpers
For configuration purposes, the phyCORE-i.MX 6 has several solder jumpers, some of which
have been installed prior to delivery.
Figure 5 illustrates the numbering of the solder
jumper pads, while Figure 6 and Figure 7 indicate the location and the default
configuration of the solder jumpers on the board.
Table 7 below provides a functional summary of the solder jumpers which can be changed
to adapt the phyCORE-i.MX 6 to your needs. It shows their default positions, and possible
alternative positions and functions. A detailed description of each solder jumper can be
found in the applicable chapter listed in the table.
Note:
Jumpers not listed should not be changed as they are installed with regard to the
configuration of the phyCORE-i.MX 6.
Figure 5: Typical Jumper Pad Numbering Scheme
If manual jumper modification is required please ensure that the board as well as
surrounding components and sockets remain undamaged while de-soldering. Overheating
the board can cause the solder pads to loosen, rendering the module inoperable. Carefully
heat neighboring connections in pairs. After a few alternations, components can be
removed with the solder-iron tip. Alternatively, a hot air gun can be used to heat and
loosen the bonds.
e.g.: J1 e.g.: J4 e.g.: J4
closed