PerkinElmer RamanMicro 200 Series, Getting Started Manual

Page: 49 / 98

Installing Your RamanMicro 200 Series . 49
Installing the Instrument in Spectrum Software
You must not connect the instrument USB cable or the microscope alignment camera USB
cable to the PC before the Spectrum software has been installed.
NOTE: A PerkinElmer Service Representative will install the Spectrum software on the PC
and add set up your instrument in the software. However, details of the software
installation can be found in the
Spectrum Administrator’s Guide
(part number
L1050095).
After the software is installed, you should switch on your Raman instrument. Wait a few
moments for your instrument to initialize and then connect the microscope alignment camera
USB cable to the PC.
The instrument then needs to be added to the software. See “Installing a Raman
Instrument” in the
Spectrum Administrator’s Guide
(part number L1050095). You can add
multiple FT-IR spectrometers to Spectrum on the same PC as a Raman instrument. However,
you can only add one Raman instrument to Spectrum.
You should now continue to connect the fiber optic cables for any fiber optic probe or
triggered fiber optic probe to the RamanMicro 200 Series instrument, as described in
Attaching and Removing the Fiber Optic Probe
on page 59.
NOTE: For details of how to use a triggered fiber optic probe, see Raman Triggered Fiber
Optic Probe User’s Guide
(part number L1321940).