IntelliTouch
®
Control System User’s Guide
21
QuickTouch Wireless QT4 Remote Controller
The QuickTouch QT4 wireless remote controller provides switching of up to four circuits. It is typically
used for activating the spa circulation, and for operating three auxiliary pieces
of equipment (such as lights, jet pump, air blower, waterfall, etc.).
Each of the four functions on the QT4 remote controller has an ON and an
OFF button. To switch a circuit on or off, press and hold the appropriate
button for at least a full second. For information about setting up the QT4
remote, see “Configuring Remote Control Button Circuits (iS4, iS10, QT4
QuickTouch, and Phone Remote), on page 81.
You can assign a circuit to any one of the four buttons. The factory default
setup is::
•
SPA
button activates the spa circuit.
•
A
button activates
Auxiliary 1
circuit.
•
B
button activates
Auxiliary 2
circuit.
•
C
button activates
Auxiliary 3
circuit.
Note:
To control circuits other than Spa, AUX 1, AUX 2 and AUX 3, it is possible to make
adjustments through the Indoor Control Panel or MobileTouch wireless control panel.
IMPORTANT:
The QT4 remote may be used with wet hands, but should never be submersed in
water, as this could damage the unit. If accidental submersion occurs, dry unit out by removing
battery cover and removing battery. Position unit so that water can drain out. Replace the battery
cover when the unit is completely dry.
QuickTouch QT4
Wireless Remote
Controller
IntelliChlor
®
Salt Chlorine Generator
(Accessory)
The IntelliChlor salt chlorinator uses a process known as
electrolysis to produce Sodium Hypochlorite (liquid chlorine)
from a low concentration of salt added to the pool water.
Hypochlorite kills bacteria, oxidizes organic material, and kills
algae, then reverts back to salt. IntelliChlor then reuses the
salt and the process starts over again. The IntelliChlor system
is comprised of the Power Center and Electrolytic Cell. The
IntelliChlor Electronic Chlorine Generator system consists of
one or more of the following:
Power Center (P/N 520556):
Provides power and controls to and from the IntelliChlor cell.
IC 20 Cell (P/N 520554):
Designed for pools up to 20,000 U.S. gallons (75,000 liters). The cell will
produce the equivalent of 0.70 pounds of pure chlorine per 24 hours of continuous pool pump run time.
The IC20 cell uses two terminal blades and five bi-polar blades.
IC 40 Cell (P/N 520555):
Designed for pools up to 40,000 U.S. gallons (150,000 liters). The cell will
produce the equivalent of 1.40 pounds of pure chlorine per 24 hours of continuous pool pump run time.
The cell uses three terminal blades and ten bi-polar blades.
IC 60 Cell (P/N 521105):
Designed for pools up to 60,000 U.S. gallons (227,124 liters). The cell will
produce the equivalent of 2 lbs. of pure chlorine per 24 hours of continuous pool pump run time. The
IC60 cell uses a total of 15 blades (three terminal and twelve bi-polar blades).
IntelliChlor “dummy” bypass cell (P/N 520588):
Recommended for new pool start-up.
Note:
For IntelliChlor setup information, see “Chlorine Generator,” on page 54.
IntelliChlor with Power Center
Summary of Contents for INTELLITOUCH
Page 9: ...vii IntelliTouch Control System User s Guide BlankPage...
Page 126: ...NOTES...
Page 127: ...NOTES SAVE THESE INSTRUCTIONS...
