IntelliTouch
®
Control System User’s Guide
23
Section 3
Preparing the System for Initial Start-up
Setting up the IntelliTouch System
Use the following recommended steps to configure the IntelliTouch system using the Indoor Control
Panel or MobileTouch wireless controller.
1. Main screen preference settings (page 33)
Setup the Indoor Control Panel main screen. Set the system clock and what circuit names you wish to
display on the main screen.
2. Assign circuit names (pages 34-37)
Assign circuit names for output auxiliary equipment.
3. Creating custom names for auxiliary circuits (page 38)
There are twenty (20) user-defined circuit names available for identifying unique equipment (see page
38).
4. Assign a circuit function to a circuit name (page 79)
From your worksheet
Programmable Settings
section, assign circuit functions to all circuits that are
not marked
GENERIC
. Nothing needs to be done if the circuit is GENERIC (simple ON/OFF when the
button is pushed). From the
Circuit Functions
screen, you can also assign special logic (IntelliBrite,
MagicStream, SAM, Floor Cleaner etc.) to a circuit by selecting one of the circuit functions. See page 41
for the complete list of circuit functions.
5. Create and assign a feature circuit name (page 79)
Review the temporary circuit names from the worksheet (page 89), create and assign circuit names to
the auxiliary (AUX) connections. On the
Assign Circuit Screen
, auxiliary circuit names are assigned
through
Displays 1 through 4
. Displays 1 through 4 correspond to the main Load Center or Power
Center (Display 1) to which they are wired. Display 2 through 4 may be additional Expansion Centers.
Note the original names presented,
AUX 1
through
AUX 10
, correspond to the plug-in location of
the relay on the Outdoor Control Panel in the main Load Center or Power Center. Feature circuits are
assigned on the
Feature Circuit
screen. Select from the available list circuit names. For a complete list
of circuit names see page 37. Up to 20 additional custom circuit names can may be custom created (see
page 38). For
Macro
circuits see page 80.
6. Configure valve actuators controlled by AUX or feature circuit (page 78)
Assign which circuits will activate which valves (A and B or optional C, D, E). If more than one circuit
must operate the same valve, then one Feature Circuit may be created and configured to activate the
valve. Then create Feature Circuits for all other circuits and use the Macro function to activate the valve
along with any relay connections.
Summary of Contents for INTELLITOUCH
Page 9: ...vii IntelliTouch Control System User s Guide BlankPage...
Page 126: ...NOTES...
Page 127: ...NOTES SAVE THESE INSTRUCTIONS...
