Pazzles Mini Creative Cutter, User Manual

Page: 21 / 140

Chapter 2 Installation and Setup
Creative Cutter MINI 13
Figure 12
Unless you reinstall the software, you should not need to make further changes to the
Vectorization settings.
Select the Plotter
1 Open Pazzles Creative Cutter.
2 Click Settings , and then click Plotter Codes . When you do, the Setup Plotter box opens.
3 Click Add/Remove and then select MINI MC270 from the list of Active Plotters.
4 Click Accept/Save .
Select the Port
In the Port box, click COM port and then select the one assigned (see “Determine the Port the
USB to Serial Was Assigned To” on page 9). Try a test cut. (See “Basic Procedures for Using
the Mini Creative Cutter” on page 21.)
IMPORTANT: Do NOT leave the Creative Cutter Mini on for extended
periods of time!!!
NOTE: When unplugging the Mini, always connect power and then the USB. If using a laptop,
turn off screen savers & sleep mode. This causes the ports to ‘go to sleep’. If this happens you
must unplug and re-plug your cutter back into your computer to re-establish connection.
Working With the Blade
The cutter is delivered with the blade inserted properly into the blade-holder unit.
Characteristics of Properly Installed Blades
Take note of how far the blade is installed in the casing—a properly-installed blade is barely
visible. Use the blade gauge included with the cutter to determine the proper blade length.
See figure 15 on page 16.
Many factors affect the life of your blade.
• The weight of the paper being cut.
• The composition of the paper being cut.
• The experience of the person doing the cutting. The life of your blade will depend on the
improvements to your technique that come with practice.
Proper adjustment and correct pressure will ensure you derive maximum longevity from your
blade.