3 Installation
980-001-0210K
NetPath 100 User’s Manual - Installation Guide
3-3
November 2000
Connections
NetPath 100 has connectors on the rear panel for power and input/output connections.
Rear panel connectors and controls are shown and described in Figure 3-2 and Table
3-1.
Figure 3-2 NetPath 100 Rear Panel (Basic)
D ATA P O R T
AU X 1
AU X 2
T1
L IN E
M O D E M
L IN E
C O N FIG U R ATIO N
C O N FIG
O
N
1 2 3 4 5 6 7 8 9 1 0 1 11 2
O
N
1 2
F U S E
2A/25 0V
S L O W B L O W
5x20 m m
90-250 V AC
.5A
50-60 H z
C O N TR O L
O U TP U T
FO R C O N T INU ED PR O T E C T IO N AG AINS T RIS K O F FIR E ,
R EP LAC E O N LY W IT H SAM E T Y P E AND RAT IN G O F FU SE .
"C AU TIO N "
N V M
R E S E T
Table 3-1 Basic NetPath 100 Input/Output Connectors and Control Specifications
Connectors
Description
Power Connector
Internal Power Supply with IEC 320 power cord.
Control Output
4-pin keyed connector to control Model 467 Power Control Unit.
Data Port
DB-44, high-density connectors provide the following interfaces,
selected by the interface cable used:
EIA-530
EIA-530-A
ITU-V.35
ITU-X.21-NS (Non-Switched)
AUX 1, AUX 2
8-pin modular connectors, EIA-232
NVM Reset/Config
Recessed push button that causes the unit’s NVM to be cleared if pressed and held
(approximately four seconds) during the unit’s power-up self-test.
T1 Line
8-pin modular connector, RJ48C
Modem Line (Analog)
6-pin modular connector, RJ11C
DIP Switches
One 2-position and one 12-position DIP switch for the initial setting of the DLCI
address, the DS0 configuration for the T1 link, and the CSU/DTE parameters.
