4 Operation
4-16
NetPath 100 User’s Manual - Installation Guide
980-001-0210K
November
2000
CSU / DTE
Configuration
The CSU / DTE Configuration screen allows you to view and alter parameters for the
CSU and DTE interface operations.
The CSU / DTE Configuration screen is shown in Figure 4-8.
Figure 4-8 CSU / DTE Configuration Screen
1. T1 ID - Enter an ID for this T1.
2. Data Rate - Displays the data rate which results from the settings for “Number of
DS0’s” and “DS0 Format.”
3. Number of DS0’s, Starting DS0, and DS0 Pattern - Select which DS0s will be
used to form the data payload.
4. DS0 Format - Select data rate for all DS0s in the payload.
5. Build Out - Selects the Line Build-Out value for the T1 line connection.
6. Ones Dens - Selects the Ones Density format to be used.
7. T1 Framing - Selects T1 Framing format to be used.
NOTE: ANSI or AT&T are ESF format, SF includes D4.
8. DTE TxD Clk - Configure the DTE to clock in the Tx data based on either the
DCE (NP 100) supplied clock, or the DTE (cable loop or router) supplied clock.
9. Link Err Thres - Disables or sets the threshold of Rx Errored Seconds plus
Unavailable Seconds which when reached or exceeded will cause an alarm to be
declared.
**************************** CSU / DTE Configuration ***************************
Name: F@43802
T1 ID [I=]: NONAME
Data Rate: 1344 kbs Build Out [B=] T1 Framing [T=]
>>1) T1-0<< >>1) ANSI<<
Number of DS0's [N=]: 24 2) T1-7 2) AT&T
Starting DS0 [S=]: 1 3) T1-15 3) SF
1 thru 24 4) T1-22
DS0 Pattern [P=] DS0 Format [F=] Ones Dens [D=] DTE TxD Clk [C=]
>>1) Contiguous<< >>1) Nx56 kbs<< >>1) B8ZS<< >>1) DCE<<
2) Alternate 2) Nx64 kbs 2) AMI 2) DTE
Link Err Thres [L=#]: Disabled
X to Disable or 1 thru 895 seconds
Help[?] Save[SA] Cancel[X]
>
