6 Options
980-001-0210K
NetPath 100 User’s Manual - Installation Guide
6-13
November 2000
Learn IP Add - Selects IP Address to “Learning Mode,” where unit will learn its
IP Address from the first valid Frame received after connecting. Set to “1” for
learning on “Every Connection.” Set to “2” for learning only if “Bkp # n WAN IP
Add” is set to zero.
NOTE: See the next page of this section for detailed description of SNMP IP
Address learning.
Bkp Downspeed Minimum - Sets the minimum number of B-Channel calls that
must be established for the call bundle to be considered successful. Failure to
establish a connection with that number of calls or more, will result in a tear-
down of the bundle and retries. Default setting is 1.
On - Demand: Establishes and maintains an ISDN data link(s) for the ISDN Data Port
while the DTE on that port holds DTR High. Does not affect Frame Manager.
NOTE: Demand operation is not supported when using an X.21 electrical interface.
Dmd Downspeed Minimum - Sets the minimum number of B-Channel calls
that must be established for the call bundle to be considered successful. Failure to
establish a connection with that number of calls or more, will result in a tear-
down of the bundle and retries. Default setting is 1.
Dmd LMI Holdoff - When the value is not zero, this sets the time delay between
Network LMI returning to a good state (after having failed) and the unit notifying
the DTE by restoring LMI to the dedicated User Port. The process is initiated by
the DTE raising the DTR signal on the ISDN User Port to establish a Demand
Call and the unit finding the Network LMI in a failed state. This can be viewed as
using the Demand Port for backup operation.
Dmd Rtry Count - Sets the number of retry attempts to establish a backup
connection on each set of phone #’s (Primary then Secondary). Valid range is
from 1 to 4.
Dmd Rtry Holdoff - Defines the delay between each retry attempt. Valid range
is from 1 to 15 minutes.
Assign to Backup / Demand - Designates which B Channel(s) will be used for
Backup operation and which B Channel(s) will be used for On-Demand operation.
Issuing “B=” or “D=” commands without any parameters deselects all associated
B Channels.
Primary & Secondary Dial #n - Enter the phone numbers to be dialed to estab-
lish a Backup or On-Demand connection. Numeric string (0 - 20 characters).
NOTE: For Bond/M1 IMUX selection, a single connection must be estab-
lished prior to dialing the remaining numbers. The first assigned channel in
the list and its number will be used for the initial call. All other dial numbers
are ignored.
NOTE: For On-Demand ML-PPP IMUX selection, a router LCP Time-Out
of less than 3 minutes may prohibit the dialing of secondary numbers.
