4 Operation
980-001-0210K
NetPath 100 User’s Manual - Installation Guide
4-11
November 2000
Modem Status -
Fault: Highest priority fault that disrupts modem operation.
Connection: Currently active modem assignment.
Valid items are: Base module, AUX 1 Port, AUX 2 Port,
Option module or (blank) if none active.
Aux Port Status -
Aux1 DTR: State of DTR Lead for the interface, ON or OFF.
Aux2 DTR: State of DTR Lead for the interface, ON or OFF.
Aux2 Alm: (blank).
NOTE: Contact Sense feature has been obsoleted.
See “Aux2 Setup” on page 14 of this section of the manual.
High Speed Interface Status -
DTR: State of DTR lead, when Power is being detected from the DTE.
States are: ON, OFF or (blank) if Power OFF.
RTS: State of RTS lead, when Power is being detected from the DTE.
States are: ON, OFF or (blank) if Power OFF.
Power: ON or OFF based on sensing voltage on Tx data lead(s) from the DTE.
Interface: Interface adapter cable currently installed.
Types are: ITU-V35, EIA-530, EIA-530-A, ITU-X21-NS or
(blank) if none.
Commands:
DevConfig [DC] - Advances to Device Configuration Screen.
CsuConfig [CC] - Advances to CSU / DTE Configuration Screen.
FrameConfig [FC] - Advances to Frame Manager Configuration Screen.
PvcConfig [PC] - Advances to PVC Performance Configuration Screen.
MonConfig [MC] - Advances to Protocol Monitor Configuration Screen.
DevTest [DT] - Advances to Device Status / Test Screen.
CsuStats [CS] - Advances to CSU Statistics Summary Screen.
FrameStats [FS] - Advances to Frame Manager Statistics Summary Screen.
PvcStats [PS] - Advances to PVC Statistics Summary Screen.
MonStats [MS] - Advances to Protocol Monitor Statistics Summary Screen.
SnmpConfig [SC] - Advances to SNMP Community Access Configuration Screen.
TrapConfig [TC] - Advances to SNMP Trap Manager Configuration Screen.
TopStats [TS] - Advances to Top Talker/Conversation Statistics Summary Screen.
Help [?] - Advances to “Help” for System View screen.
Logout [LO] - Logs out from system.
AutoUpdate [AU] - Causes the status fields on the current screen displayed to refresh
automatically (approximately every five seconds).
To proceed setting operating parameters, select Device Configuration screen [DC] by
typing “DC” followed by ENTER.
