4 Operation
4-12
NetPath 100 User’s Manual - Installation Guide
980-001-0210K
November
2000
Device
Configuration
The Device Configuration screen allows you to view and alter parameters for System
and Modem operations.
The Device Configuration screen is shown in Figure 4-7.
Figure 4-7 Device Configuration Screen
All NetPath 100 screen entries and selections are made by entering the two or three
characters shown in brackets next to the field titles, equals “=”, then entering the value
or string followed by ENTER.
Example: To enter “ABC” in the Name field,
Type: N=ABC and press ENTER
Current selections are highlighted by bracketing with, “>>”.....“<<” characters.
Device Configuration
1. Enter Name and Location of this NetPath 100 installation (optional but
recommended).
2. Enter Contact Name and Phone Number of local technical contact (optional).
3. Enter WAN IP Address for SNMP management of the NetPath 100. If set to the
default value as shown in Figure 4-7, the IP Address will be learned automatically.
The first valid IP Address will be “learned”. Once a value is entered or learned
automatically, it will replace the “0.0.0.0” value and auto learning will be
discontinued unless configured for “relearn” mode (see “WAN Mgmt DLCI” on
page 4-18 of this section.
4. Enter Payload or CPE (private user) IP Address for PVC management of the
NetPath 100.
***************************** Device Configuration *****************************
Frm Mgr [Z=]
Name [N=]: F@43802 >>1) FrRelay<<
Location [L=]: Fair Lawn, N.J. 2) ClrChan
Contact [C=]: J. Jones
WAN IP Add [I=]: 0.0.0.0 Payload/CPE IP Add [J=]: 0.0.0.0
------ Modem Setup / Model: RC144DPi Rev CA V1.610-CS29F ------
Dial String [D=]:
Answer Call [AC=]:
Aux1 Setup [A1=]: A96N8AT&K0Q1^MATA
Aux2 Setup [A2=]: A96N8AT&K0Q1^MATA
(NOTE: Text & IP entries may not be made in combination with other parameters!)
ModemLine [M=] RtryCount[R=#]:2 RtryHoldoff[H=#]:30 InactivityLogout[O=#]:15
1) Test 1 thru 4 1 thru 60 seconds 1 thru 30 minutes
>>2) No Test<<
WAN Encap [T=] MTUSize[W=#]:1492 View Pswrd [P=]:11111111
P/C Encap [U=] >>1) Learning<< 88 thru 4000 Octs Test Pswrd [E=]:22222222
>>1) Raw<< 2) Raw Config Pswrd [F=]:33333333
2) IETF 3) IETF ---- CHAP Name/Key --- Super Pswrd [S=]:********
4) SNAP [CN=]:CHAPNAME******** Super Verify [V=]:********
Help[?] Save[SA] Cancel[X] [CK=]:**************** System Pswrd [Y=]:DISABLED
>
