Panasonic LP-400 Series, Operation And Maintenance Manual

Page: 61 / 334

61
2-1-2 Installation of LP-400 Series Head
WARNING
• Install the product so that the laser beam path does not cross the eye height.
• The laser beam path shall be enclosed with protective enclosure and make sure
it is not exposed with direct light or reflected light.
⿎ Installation Method
• Install the head on a plate with a thickness of 10 mm to 15 mm which is made of aluminum or other material with
radiation performance equivalent to that of aluminum.
• For the installation dimension, refer to the outer dimension in “1-4-1 LP-400 Series” (P.40).
• Fix the head with the following conditions.
Head type Fixing position Fixing screw Inserting length of the screw Tightening torque
Standard head Bottom face M6 screws at 6
positions 7 mm to 10 mm 3.0N ・ m or below
Tower head Rear face 7 mm to 10 mm
Bottom face
(Laser emission port side) 5 mm to 7 mm
Laser marker
Washer thi stand thick
Inserting length of the screw (See above table for the length.)
M6 screw
120
180
180
182
150
90
55
180
130
180
200
113
87
Standard Head Model
Tower Head Model
Notice
• Check the length of the screw and install it. Using improper screws and forcibly tightening them might damage the
product.
ME-LP400V-OP-6