Panasonic LP-400 Series, Operation And Maintenance Manual

Page: 174 / 334

174
Description
2 Offset:
The whole screen is offset for each file.
Rotation Offset:
Rotates the object to the rotation direction around the original point.
Setting Range -180.00 to +180.00 degree (0.01 degree unit)
+Y
-Y
+X
-X
Rotation (+) Rotation (-)
X/Y Offset :
Shifts the marking position to the X/Y direction.
Setting Range
-45.000 to +45.000 mm (LP-V10)
-55.000 to +55.000 mm (LP-430 / LP-420 / LP-410)
-80.000 to +80.000 mm (LP-435 / LP-425 / LP-V15)
-27.500 to +27.500 mm (LP-431 / LP-421 / LP-411 / LP-W052)
3 Overwriting Frequency :
Number of overwriting. The number of overwriting marking is specified by one trigger input.
Setting Range 1 to 99 times
Notice
• Overwriting marking and marking of bold character may affect the quality of marking. Check it by a trial before using
these functions.
• The function of overwriting is unavailable for the marking to flying object.
4 Overwriting Interval :
The interval period at overwriting is set.
Setting Range 0.0 to 9.9 seconds or 0 to 60 seconds
5 Kerning :
Set the level of spacing between characters. The lower the value is, the smaller the spacing is. This feature is
enabled when the “character spacing” is set to “proportional”.
Level 1 : Minimize the origin point of the character interval with this condition. The letter-spacing of the letter “i”
and “l” (small letter “L”) are recognized as “0”.
Level 2 : Set the origin point of the character with intermediate degree between the character interval set with
Level 1 and Level 3. The character width such as “i” and “l” (small letter “L”) becomes 1/4 of character
width.
Level 3 : Maximize the origin point of the character interval with this condition. The character width such as “i”
and “l” (small letter “L”) becomes 5/8 of character width.
Reference
• Set the interval balance of the character by the setting of setting, and set the character interval of the character using
the character condition.
• When not using the proportional function, the kerning setting is invalid.
ME-LP400V-OP-6