Panasonic LJ-NA02, Installation Manual

Page: 122 / 132

22
User's Manual
and fire
with fingernails or other hard objects.
surface first.
or fingerprints on the surface of the front lid and base cover.
10. Inspection and Maintenance
10-1 Inspection
• Check the exterior of the product for damage, rust and dents. Contact the installer if a large dent and/or deformation
is found.
• Consult the installer for information on regular maintenance/inspection of the product.
10-2 Maintenance
Use a soft cloth to gently wipe off any dirt
For stubborn dirt:
(1) Remove dust/debris from the
(2) Dampen a soft cloth with clean water or neutral detergent (diluted to a ratio of 1:100).
(3) Wring the cloth tightly.
(4) Finally, wipe off all moisture from the surface.
Notice:
* Stop operating the product before cleaning it. The surface temperature may become hot while the product is in operation.
* Do not clean the product by sprinkling water over it (never use a high-pressure water hose).
* Do not use a hard cloth and/or rub the surface strongly. Doing so may cause scratches on the surface.
* Keep the surface away from volatile substances such as insect repellents, solvents and thinners.
Failing to do so may result in degradation of the paint surface quality and/or peeling of the paint coating.
* The surface of the display panel has been treated with special processing and is prone to damages. Exercise caution not to hit or
damage the surface
* Do not allow rubber or PVC materials to come in contact with the cabinet for an extended period of time. This may result in
degradation of the surface quality.
10-3 Installation Check List for the Storage Battery System
■
Standard Installation Location
Installation location Outdoor/Indoor*
Storage temperature range [°C] -20 to +40°C
Operating temperature range [°C]
0 to +40°C
(Discharging: -10 to 40°C)
Operating humidity [% RH]
0 to 90% RH
(No dew condensation)
Maximum atmospheric pressure/altitude Lower than 1000m above sea level
Sunlight Protected from exposure to continuous direct sunlight.
* When the product is installed in the building or house, it is necessary to ensure all local building regulations are complied with.