Panasonic LJ-NA02, Installation Manual

Page: 94 / 132

94
Installation Manual
8-3. Stand-alone Operation Test
run finishes automatically and the test
stand-alone breaker back ON after the test run has completed. Otherwise no power will be
■
Switch the Stand-alone Breaker Back ON.
stand-alone breaker back ON after the test runs have been completed. Otherwise, no power
Perform test runs of the stand-alone operations.
● Be sure to turn OFF the backup breaker during a test run. Otherwise, it may result in the failure of the connected
load device.
● Be sure to turn the
will be supplied to the load during the actual stand-alone operations.
■
Preparation
• Be sure to turn the stand-alone breaker to OFF.
• See the list of commands in P.52 or 8-2 and select the Stand-alone Operation test [TEST1].
■
Operation Procedure
Test Run Selection
Stand-alone
Stand-alone
Operation Test
Running
Automatic
Result
OK (Normally Complete)
NG (Abnormal Termination)
• Select the stand-alone test [TEST1] in the test run selection prompt.
• With the Stand-alone Operation test 1 selected, press "MENU (ENTER)"
to start the test run.
• [CHE 1] is displayed during the test run.
The test run takes several minutes to complete.
• When the test is complete, the test
result is displayed.
• [ ] appears if the test run is normally completed, but if it does not
normally complete, the abnormal termination appears as [ ].
•
Press "ON/OFF(CANCEL)" after the results display, and switch to the test
run selection.
■
Abnormal Termination
• The DC protector may be turned OFF. Check that the DC protector is turned ON.
• The setting value for the Remaining Battery Level Setting may exceed the remaining battery level. Change the setting value.
• When the Stand-alone Operation test completes normally, be sure to turn the stand-alone breaker ON again.
● Be sure to turn the
supplied to the load connected to the stand-alone circuit during a power cut.
* Reference 4-3: How to check the voltage with the Grid terminal.