Panasonic LJ-NA02, Installation Manual

Page: 68 / 132

68
Installation Manual
7. Setting Parameters for Grid Operator
7-1. Setting Parameters
To operate this system normally, it is necessary to set the operation parameters. Note that the system may fail to
operate normally if these parameters are not properly set.
● The system cannot operate normally if the operation data have not been set correctly.
● Only the grid operator can set up and operate this parameter. The password is not in this installation manual.
7-2. Switching to the Parameter Item Selection Mode
■
Preparation
• Set the storage battery system to the stopped state in the normal state. The system can only be switched to the
parameter setting mode while it is in a stopped state.
■
Operation Procedure
Normal State
Stopped (Grid-connected)
3 sec
Password match
1 sec
Stopped (Stand-alone)
Password Input Parameter Item Selection
Grid-connected
Protection Level Setting
Initial Display
+
• Press "DATA (▲)" + "MENU (ENTER)" simultaneously for three seconds to switch to the password input mode.
• Enter the password when prompted. The system switches to the parameter item selection mode if the entered
password is correct.
(See 6-3 Password Input for details on the password input mode)
• The initial display [no4.00] of the parameter item selection mode appears if the mode switch is successful.
• To return to the normal state, press "ON/OFF" for one second while in the password input mode or parameter item
selection mode.