Panasonic KX-NS1000, Installation Manual

Page: 231 / 416

5.6 Programming an H.323 QSIG Network
There are 2 methods to programme the Virtual 16-Channel VoIP Gateway Card (V-IPGW16 card) to establish
VoIP communications between PBXs at different locations, as follows:
PBX code method The caller dials the unique PBX code of the PBX to which the called party is
connected, in addition to the destination number.
Extension number
method The caller dials only the destination number of the called party to call through
PBXs at different locations (hence there are fewer digits to dial than with the
PBX code method).
Note
•
For a detailed explanation about each method, refer to "4.3 Private Network Features" in the Feature
Guide.
•
Portions of this software are © 1996–2006 RADVISION Ltd. All intellectual property rights in such
portions of the Software and documentation are owned by RADVISION and are protected by United
States copyright laws, other applicable copyright laws and international treaty provisions. RADVISION
and its suppliers retain all rights not expressly granted.
5.6.1 Assigning the Hunt Pattern
The hunt pattern determines how to route incoming calls through virtual IP trunks to the PBX. The procedure
below demonstrates the process of programming the hunt pattern of the local PBX. After the hunt pattern at
the local PBX has been fully assigned, repeat the procedure for the hunt pattern at the remote PBX with the
appropriate setting values.
Status Light
1. a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Click Virtual
®
V-IPGW16 .
c.
If the V-IPGW16 card’s status light is green, move
the mouse pointer over the card, select
Ous from the
menu that appears, and then click OK on the
dialogue box. The status light will turn red.
d.
Move the mouse pointer over the installed
V-IPGW16 card. A menu will be shown under the
mouse pointer.
e.
Click Shelf Property .
f.
Click Hunt Pattern .
2.
a.
When using the PBX code method:
In the Leading Number cell, type the local PBX
code and extension starting digit.
When using the extension number method:
In the Leading Number cell, type the local extension
starting digit.
b.
Click OK to return to the Shelf Property screen.
Installation Manual 231
5.6.1 Assigning the Hunt Pattern