Panasonic KX-NS1000, Installation Manual, Page: 224 / 416

d.
<At the Master Unit>
Click Export to export the setting file.
The setting file created by the Master unit PBX is required to add a Slave unit to the network.
Note
The Export button will also be available when adding a Slave unit.
<At a Slave Unit>
Click Import to import the setting file exported from the Master unit.
Note
•
The settings become active after restarting the Slave unit.
•
In the imported data, if the VPSS's Master Site IP Address (WAN) cannot be resolved, a
window for setting the Master Site IP Address (WAN) is displayed. Set the Master Site IP
Address (WAN) . This setting can also be set later.
For details, refer to "27.9 Router Configuration—VPN—[3-1] VPSS" in the PC Programming
Manual.
e.
Click Next .
When not using the built-in router:
a.
In Built-in Router — Connection Mode , select Disable .
b.
Click Next .
*1 Valid IP address range: "1.0.0.1" to "223.255.255.254"
*2 Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except "0.0.0.0" and "255.255.255.255")
*3
Up to 64 characters.
*4
Up to 24 characters.
6.
In Registration Setting , the IP Terminal Registration Mode and the One Look Networking (Trial
Activation Key) can be set.
a.
Select the IP Terminal Registration Mode :
•
Manual : Select this mode to manually register IP terminal information.
•
Full Automatic : Select this mode to automatically register IP terminal information.
•
Extension Number Input : Select this mode to automatically register IP terminal information except
its extension number. The extension number can then be registered from the IP telephone
manually.
Note
•
Full Automatic and Extension Number Input registration methods may not be available for
certain types of IP terminals. In such cases, select the Manual registration method.
•
For more information about the IP terminal registration modes, refer to "5.9.1 Registering
IP Telephones".
b.
For One Look Networking (Trial Activation Key) , specify whether to activate the 60-day One-look
Networking Trial Activation Key.
–
If Active is selected, the 60-day trial will begin when the Easy Setup Wizard is completed.
–
If Non Active is selected, you will have to activate the trial manually in order to use One-look
Networking Features on a trial basis.
c.
Click Next .
If Slave has been selected in step 2 , the Easy Setup Wizard will finish at this step. If LAN settings have
been changed from their default values in step 4 , you will be prompted to restart the PBX. Click OK to
restart the PBX.
To add the PBX as a Slave unit PBX to the One-look network, use the Add Site Wizard from the Master
unit PBX’s Home Screen.
224 Installation Manual
5.4.1 Easy Setup Wizard