Panasonic KX-NS1000, Installation Manual

Page: 206 / 416

Feature Numbers, Other PBX Number, Extension Number, Quick Dial Number
•
Data conversion does not support system data from KX-TDA series PBXs. To convert KX-TDA data,
first convert it to KX-TDE data using the PBX Replacement of Unified Maintenance Console and then
convert that data to KX-NS1000 data.
•
Data for cards that are supported in legacy gateways connected to the KX-NS1000 can be converted
from KX-TDE series and KX-NCP series PBXs.
•
Data for IP-EXT16 cards in a KX-TDE series or KX-NCP series PBX will be converted for use with a
V-IPEXT32 card in the KX-NS1000. IP-PTs that had been connected to the IP-EXT16 card must be
registered again to the V-IPEXT32 card in the KX-NS1000.
•
PBX voice data (e.g., ESVM, SVM, OGM) is not converted.
•
Data conversion for a SLC/LCOT/BRI card in the KX-NS1000 is not supported; the number of ports in
these cards is too small.
•
After conversion, if CSs are connected to both Slave units and the Master unit, you must change the
settings so that all CSs are connected to the Master Unit.
•
Data that is not supported by the data conversion is shown in the following table.
Unsupported Item Default Setting
Time Mode
Current time mode Location setting default
Time mode switching time (manual mode) Not Stored
Wired/Wireless extensions
Timed Reminder Not set
Station Lock Unlocked
Remote Station Lock Unlocked
Extension Call Charge Total Total cleared
Not Ready/Ready (Wrap-up) Wrap-up status cleared
LCS On/Off Location setting default
Room Status (Check In/Check out/Not Ready/
Cleaned Up) Location setting default
Auto Answer Location setting default
Absent Message Status Not set
Saved Number Redial Number cleared
ICD Group Login Status (Login/Logout) Location setting default
Message Waiting Cancelled
Incoming Log Cleared
Outgoing Log Cleared
TAM Log Cleared
Personal Absent Message Message cleared
206 Installation Manual
5.3 Starting Web Maintenance Console