Panasonic FP-XH M8N16PD, User Manual

Page: 508 / 556

Specifications
26-52

Cam pattern reading/rewriting execution confirmation area
Offset
address
Name Default Description
H58
Cam pattern reading
result
H0
Stores the result of reading processing (response code).
H0: Normal end
Other than H0: Abnormal end
H59
Cam pattern rewriting
result
H0
Stores the result of rewriting processing (response code).
。
H0: Normal end
Other than H0: Abnormal end
(Note): In the case of abnormal end, the codes in the following table are stored.
A: Available, -: Not available
Code Name Description
Object
Countermeasures
Read Write
H FF01
Cam pattern number
setting error
The set value of the
cam pattern number
is out of the settable
range.
A A
Check the set value of the
cam pattern number.
H FF02
Number of cam
pattern setting
sections setting error
The set number of
cam pattern setting
sections is out of the
settable range.
- A
Check the set number of
setting sections.
H FF03
Shift amount setting
error
The set shift amount
is out of the settable
range.
- A
Check the set value of the
shift amount.
H FF05
Start phase setting
error 1
The set start phase is
out of the settable
range.
- A
Check the set value of the
start phase in each section.
H FF06
Start phase setting
error 2
The set start phase is
the same as or
smaller than the start
phase of the previous
section.
- A
Check if the relation between
the start phases of each
section is (Start phase of
section n-1) < (Start phase of
section n).
H FF07
Start phase setting
error 3
The set start phase of
the section 1 is not 0.
- A
Always set the start phase of
the section 1 to 0.
H FF0A
Displacement setting
error
The set value of the
displacement is out of
the settable range.
- A
Check the set value of the
phase in each section.
H FF0B
Cam pattern number
setting error
The set cam pattern
number is out of the
settable range.
- A
Check the set value of the
cam pattern number in each
section.
H FF10
Cam pattern reading
not executable error 1
An axis in
synchronous
operation exists.
A -
Cancel the synchronous
operation and execute the
reading.
H FF11
Cam pattern reading
not executable error 2
An operating axis
exists.
A -
Execute the reading when no
operating axis exists.
H FF20
Cam pattern rewriting
not executable error 1
An axis in
synchronous
operation exists.
- A
Cancel the synchronous
operation and execute the
rewriting.
H FF21
Cam pattern rewriting
not executable error 2
An operating axis
exists.
- A
Execute the rewriting when
no operating axis exists.
H FF22
Cam pattern rewriting
not executable error 3
The reading request
and rewriting request
turned on
simultaneously.
- A
Check if the reading request
and rewriting request do not
turn on simultaneously.
When the reading request
and rewriting request turn on
simultaneously, the reading
request takes priority.