INF-8
6. Emergency Eject
If the cassette cannot be ejected by pressing the
EJECT button, use a screwdriver or similar tool to
press and turn the EMERGENCY screw. This enables
the cassette to be removed.
1.
Turn the power OFF.
2. Remove the rubber cap where shown in the
figure. Insert a Phillips head screwdriver into the
cross-shaped part of the EMERGENCY screw
(red).
3. While pushing in with the screwdriver, turn the
EMERGENCY screw counterclockwise until the
tape is ejected.
•
This screw needs to be rotated through about
20 turns after the first turn until the unloading
can be started.
•
This screw needs to be rotated through about
90 turns after the first turn until the tape is
ejected.
4.
Remove the cassette.
5.
Return the rubber cap to its original position.
< Notes >
•
Do not turn the EMERGENCY screw except in an
emergency.
•
Do not turn the screw clockwise. Stop turning the
screw as soon as the tape is ejected. Otherwise,
the mechanism may be damaged.
•
After the tape is ejected, the cassette holder will not
be locked even when it is closed. Be sure to turn
the power off and turn it back on to reset the
mechanism’s operation, and then close the
cassette holder.
•
A clicking sound will be heard while the
EMERGENCY screw is been turning: this sound is
made by the reel drive operation. Therefore it isn't
indication of a malfunction.
Summary of Contents for AJSDX900P - 24P DVCPRO 50
