Panasonic AJSDX900P - 24P DVCPRO 50, Service Manual, Page: 82 / 421

MECH-41
2-10. Pinch Solenoid Replacement
(Removal)
1. Disconnect the connector (A) on the P.C.Board
(A) . (Please refer item “7. Table of Connector”
about reference number of connector and name
of P.C.Board.)
Click this button , then go to item “7. Table of
Connector”.
2. Unscrew the 2 screws (A) and remove the Pinch
Solenoid Unit as shown in Figure 2-10.
3. Unscrew the 2 screws (B) and remove the Pinch
Solenoid Angle as shown in Figure 2-10.
4. Unscrew the 2 screws (C) and remove the Pinch
Solenoid from the Pinch Solenoid Base as shown
in Figure 2-10.
(Installation)
1. Install the new Pinch Solenoid following the
removal steps in reverse order.
2. After installation, perform the Pinch Solenoid
Position Adjustment.
Figure 2-10
2-11. Pinch Solenoid Position
Adjustment
SPEC.
T = 0.3 mm
TEST
Gap T
ADJUST
Screw (A) and Hole (B)
MODE
EJECT (Power OFF)
TOOL
Eccentric Driver (VFK0357)
1.
Confirm the power is turned off.
2. Push the pinch roller by hand to be close to
capstan.
3. Push the pinch solenoid by hand so that the
pinch roller contacts capstan.
4. Loosen the two screws (A) and adjust the hole
(B) by VFK0357 so that gap (T) is within the
specification.
5. The position to confirm Gap, is at spring
scratch to Plate (C) side.
Figure 2-11