Panasonic AJSDX900P - 24P DVCPRO 50, Service Manual, Page: 92 / 421

MECH-51
(Installation)
1. Remove the Shield Case from the New A/C Head
and solder the lead wires to New A/C Head.
(Refer to Figure 2-23-3)
2. Reinstall the shield case to A/C Head.
3. Install the A/C Head to A/C Head Plate by
tightening 2 screws (A), then set to parallel the
gap between A/C Head and A/C Head Plate.
4. Install the A/C Head Unit.
5. Hang on the Head Height Adjustment Spring and
tighten the Nut (C).
6. Clean the surface of the A/C Head.
Figure 2-23-3
A/C Head Cable Color Connector
1 Pink Yellow
2 White
3 Pink Red P1
4 White
5 Pink Green
6 White
7 White Yellow P30
8 Black
<A/C Head Adjustment>
1. After change the A/C Head, please perform the
following steps.
NOTE:
PG Shifter and CUE AUDIO adjustment
procedures are mentioned on Electrical
Adjustment Procedures .
START
1-14. A/C Head Tilt Adjustment
NOTE: PG Shifter Adjustment
1-18. A/C Head Azimuth & X-value Adjustment
1-15. A/C Head Height Adjustment
END
1-29. to 1-33. LISTA Adjustment
NOTE: CUE AUDIO Adjustment
1-34. Self Rec/Play Envelope
Waveform Confirmation
1-19. Compensation Adjustment of X-value