Panasonic AJSDX900P - 24P DVCPRO 50, Service Manual, Page: 95 / 421

MECH-54
2-26. MIC Sensor SW Unit
Replacement
(Camera Recorder only)
(Removal)
1. Disconnect the connector (A) on the P.C.Board
(A) . (Please refer item “7. Table of Connector”
about reference number of connector and name
of P.C.Board.)
Click this button , then go to item “7. Table of
Connector”.
2. Unscrew the 2 screws (A) and remove the MIC
Base Unit as shown in Figure 2-26.
(Installation)
1. Install the new MIC Base Unit according to the
opposite procedures of removing.
2. Confirm that the M cassette touches to MIC Base
Unit properly.
Figure 2-26
2-27. Reel Drive Motor Unit
Replacement
(Studio VTR only)
(Removal)
1. Disconnect the connector (A) on the P.C.Board
(A) . (Please refer item “7. Table of Connector”
about reference number of connector and name
of P.C.Board.)
Click this mark , then go to item “7. Table of
Connector”.
2. Unscrew the 2 screws (A) and remove the Reel
Drive Sensor P.C.Board as shown in Figure 2-27.
3. Unscrew the 2 screws (B) and remove the Reel
Drive Motor Unit as shown in Figure 2-27.
(Installation)
1. Install the new Reel Drive Motor Unit following the
removal step in reverse order.
Figure 2-27
2-28. L-M Release Angle Unit
Replacement
(Studio VTR only)
(Removal)
1. Unscrew the 2 screws (A) and remove the L-M
Release Angle Unit as shown in Figure 2-28.
(Installation)
1. Install the new L-M Release Angle Unit following
the removal steps reverse order.
Figure 2-28