Panasonic AJSDX900P - 24P DVCPRO 50, Service Manual, Page: 122 / 421

ELE-9
“A”
portion
STEP
Portion “A” has
Step.
GAIN on WFM: 5X
2-10. AD Level Fine Adj.
BOARD CAM DSP Board
TP VIDEO OUT (R/G/B) (75 ohm terminated)
ADJ. EVR
SIGNAL Internal TEST Ramp Signal
MODE -
M. EQ. Waveform Monitor
SPEC. White Level = Color bar’s white
1. Set the OUTPUT switch to “BARS” .
2. Click the “9. AD Level Fine Adjustment” of the
camera adjustment software.
3. Confirm that the white level is 100%
±
1% and click
“OK” .
4. Set the OUTPUT switch to “CAM (AUTO KNEE OFF)” .
5. Adjust the Slider on the PC so that the white level
becomes 100% (Color bar’s white)
±
1% .
6. Click “>>” .
7. Adjust the Slider on the PC so that the white level
becomes 100% (Color bar’s white)
±
1% .
8. Click “>>” .
9. Adjust the Slider on the PC so that the white level
becomes 100% (Color bar’s white)
±
1% .
10. Click “>>” .
2-11. Pre Knee Point Adj.
BOARD PRE PROCESS Board
TP VIDEO OUT (R/G/B) (75 ohm terminated)
ADJ. EVR
SIGNAL Internal TEST Ramp Signal
MODE -
M. EQ. Waveform Monitor
SPEC. A PORTION = FLAT (No step)
1. Set the OUTPUT switch to “CAM (AUTO KNEE OFF)” .
2. Click the “10. Pre Knee point Adjustment” of the
camera adjustment software.
3. Adjust the Slider on the PC so that the waveform
becomes FLAT (no step) .
4. Click “>>” .
5. Adjust the Slider on the PC so that the waveform
becomes FLAT (no step) .
6. Click “>>” .
7. Adjust the Slider on the PC so that the waveform
becomes FLAT (no step) .
8. Click “>>” .
2-12. Pedestal Adj.
BOARD PREPROCESS Board
TP VIDEO OUT (G) (75 ohm terminated)
ADJ. EVR
F No. CLOSE
MODE CAM
M. EQ. Waveform Monitor
SPEC. PEDESTAL = 0 %
±
1 %
1. Click
the “11. Pedestal Adjustment” of the camera
adjustment software.
2. Confirm that the lens is close and click “OK” .
3. Operate the “ABB” switch on the front of the Camera
and click “OK” .
4. Adjust the Slider on the PC so that the Pedestal level
becomes 0 %
±
1 % .
5. Click “>>” .
PEDESTAL
A
GAIN on WFM: 5X
White Level (100 %)
Black Level (0 %)