Panasonic AJSDX900P - 24P DVCPRO 50, Service Manual

Page: 80 / 421

MECH-39
2-6. Main Brake Torque
Confirmation
TEST
S Reel, T Reel
MODE
EJECT (Power OFF)
TOOL
Torque Gauge (VFK71A, VFK1191A)
Torque Gauge Adapter (VFK1152)
Direction A
Refer to item “7. Table of connector”
Direction B
SPEC
Refer to item “7. Table of connector”
Click this button , then go to item “7. Table of
Connector”.
1. Install the adapter (VFK1152) to the torque
gauge (VFK71A).
2. Put the torque gauge on S Reel and turn the
torque gauge to direction A until S Reel slips
against brake.
3. Confirm the torque is within the specification.
4. Put the torque gauge on T Reel and turn the
torque gauge to direction A until T Reel slips
against brake.
5. Confirm the torque is within the specification.
6. Install the adapter (VFK1152) to the torque
gauge (VFK1191A).
7. Put the torque gauge on S Reel and turn the
torque gauge to direction B until S Reel slips
against brake.
8. Confirm the torque is within the specification.
9. Put the torque gauge on T Reel and turn the
torque gauge to direction B until T Reel slips
against brake.
10. Confirm the torque is within the specification.
Figure 2-6
2-7. Supply & Take-up Brake Arm
Unit Replacement
(Studio VTR only)
(Removal)
1. Press the iron core of Brake Solenoid to release
the Brake.
2. Remove the cut washers (A) and remove the
supply and Take Up Brake Arm Unit as shown in
Figure 2-7.
(Installation)
1. Install the new Supply and Take-up Brake Arm
Unit follow the previous steps in reverse order.
NOTE: Hang on the Brake Arm Spring as shown in
Figure 2-7.
2. Perform the Main Brake Torque confirmation.
Figure. 2-7