Panametrics GF868, Programming Manual, Page: 57 / 167

12/1/99
1-50 Programming Site Data
Option Card Totalizer/
Frequency Outputs (cont.)
Proceed to section A for instructions on programming a frequency
output or to section B for instructions on programming a totalizer
output. If the current output was disabled above, skip both sections.
A: Programming a Frequency Output
This choice produces a frequency pulse that is proportional to the
output measurement.
The DIAG option provides access to a wide variety of diagnostics
parameters. See Chapter 3, Diagnostics, of the Service Manual for a
complete description of these options.
Table 1-15: Channel Options
Option Description
CH1 Channel 1
CH2 Channel 2
SUM CH1+CH2
DIF CH1-CH2
AVE (CH1+CH2)/2
Global Pulse Output
Press [
←]
and [
→]
and [F1]-[F4]
to specify the desired output
measurement parameter. See
Table 1-16 below for a
description of the available
options. Slot x Pulse Out A
Frequency
Output measurement
last selection appears here
VEL VOLUM +TOTL -TOTL
Table 1-16: Output Measurement Options
Option Description
VEL Flow Velocity
VOLUM Volumetric Flow
+TOTL Forward Totalized Flow
-TOTL Reverse Totalized Flow
MDOT Mass Flow
+MASS Forward Totalized Mass Flow
-MASS Reverse Totalized Mass Flow
DIAG Diagnostics