Panametrics GF868, Programming Manual, Page: 44 / 167

Programming Site Data 1-37
12/1/99
The SYSTM Sub-Menu
(cont.)
Note:
The above prompt shows the ENG versions of the available
volumetric units, as an example.
The abbreviations and definitions of all the available volumetric and
totalizer units are shown in Table 1-5 on page 1-36. The choices
shown on the option bar in the prompt screen above are determined
by the selection made at the
SYSTEM UNITS prompt screen at the
beginning of this sub-menu.
Note:
The option bar above shows English units. If Metric units are
specified in the
GLOBL menu, these will appear instead.
Global SYSTM Press
[F1]-[F4]
to select the
desired number of digits to the
right of the decimal point in the
volumetric flow rate display.
VOLUMETRIC TIME
current setting appears here
VOL DECIMAL DIGITS
current setting appears here
0 1 2 3
Global SYSTM
É
Press [F1]-[F4] to select the
desired units for the totalized
flow display. Press [
→]
to access
the additional choices of
[F1] =
KSCF
and
[F2] = MMSCF.
VOL DECIMAL DIGITS
current setting appears here
TOTALIZER UNITS
current setting appears here
ACF KACF MMACF SCF
Global SYSTM Press
[F1]-[F4]
to select the
desired number of digits to the
right of the decimal point in the
totalized flow display. TOTALIZER UNITS
current setting appears here
TOTAL DECIMAL DIGITS
current setting appears here
0 1 2 3
Chan 1 SYSTM Press
[F1]-[F4]
to select the
desired mass flow units for the
flow rate display
.
TOTAL DECIMAL DIGITS
current value appears here
MASS FLOW
current setting appears here
LB KLB MMLB TONS