Panametrics GF868, Programming Manual, Page: 39 / 167

12/1/99
1-32 Programming Site Data
The GLOBL Menu
The GLOBL menu is used to enter information that is not specific to
one of the individual channels. Information programmed via this
menu is used to compute parameters such as the sum, difference or
average of the channel 1 and channel 2 signals. In addition, several
general system parameters may be entered in the
GLOBL menu.
IMPORTANT:
When calculating the SUM , DIF or AVE readouts,
data from the
GLOBL-SYSTM
sub-menu is used. Any
conflicting data entered in the
CH1-SYSTM
or
CH2-
SYSTM
sub-menus is overridden.
The following sub-menus are included in the GLOBL menu:
•
CLOCK
- used to enter the current date and time
•
SYSTM
- used to specify the units of measure used in calculations
•
I/O - used to set up error handling and to configure analog inputs
and outputs
•
COMM - used to set up the serial communications port
•
SECUR - used to specify a programming access password.
After selecting [F3]=GLOBL at the initial programming screen, the
following screen appears:
Based on the selection made above, proceed to the appropriate section
of this chapter for instructions. Refer to Figure A-3 on page A-3 and
Figure A-4 on page A-4 in Appendix A, Menu Maps, and remember
to record all programming data in Appendix B, Data Records.
PROGRAM Start
É
Press the [
←]
and [
→]
keys and
a function key [F1]-[F4] to select
the desired sub-menu. From this
screen, press
[EXIT]
to return to
the initial User Program screen
shown on page 1-8.
Global PROGRAM
previous selection appears here
CLOCK SYSTM I/O COMM