82
Step 3
In the
ATM PVC Configuration
page, set
VPI/VCI
to
3/35
and click
Next
.
Step 4
In the
Connection Type
page, select
IP over ATM
(IPoA)
and set the
Encapsulation Mode
to
LLC/SNAP-ROUTING
, and then click
Next
.
Step 5
In the
WAN Setting
s page, enter the IP address,
subnet mask, and DNS server address provided by
your ISP. Do not select
Use the following default
gateway
. Then, click
Next
.
WAN IP address: 20.1.1.2
WAN subnet mask: 255.255.255.0
Primary DNS server: 168.95.1.1
Secondary DNS server: 168.95.192.1
Step 6
In the
Network Address Translation Settings
page,
enable the NAT and firewall. Keep default settings for
other fields. Then, click
Next
.
Step 7
Confirm the network configuration and ensure that all
settings are consistent with the data provided by your
ISP. Then, click
Save
.
Step 8
Click
Save/Reboot
to apply the changes and reboot
the DSL Router.
You can also modify the PVC 3/35. Modify the LAN IP address
and DHCP server information in
LAN
of
Advanced Setup
.
After the configuration is complete, the DSL Router WAN-side
interface is
ipa_3_35
.
If
Enable NAT
check box is disabled during the configuration,
you must configure the route on the BRAS. Otherwise, you
cannot access your ISP. In actual application,
Enable NAT
must be selected.
4.4.1.10 Adding a Bridge PVC
This section describes the procedure for adding PVC 4/35
(IPoA mode).
Click
Add
and the following page appears.
