51
Step 2
To add an ATM PVC, click
Add
.
Step 3
To delete a PVC, select the
Remove
check box in the
table and click
Remove
.
Step 4
Click
Save/Reboot
to apply the changes and reboot
the DSL Router.
Note:
After a PVC is deleted or modified, the system must be
rebooted. Otherwise, the modification does not take
effect.
The procedure for adding a PVC is described as follows.
4.4.1.1 Adding a PPPoE PVC
This section describes the procedure for adding PVC 8/35
(PPPoE mode).
Step 1
Click
Add
and the following page appears. In this page,
you can modify VPI/VCI, service category, and QoS.
Figure 39 PVC and its QoS configuration
VPI (Virtual Path Identifier)
: virtual path between two
points in an ATM network. Its valid value range is from 0 to
255.
VCI (Virtual Channel Identifier)
: virtual channel between
two points in an ATM network. Its valid value range is from
32 to 65535 (1 to 31 are reserved for known protocols).