61
Step 3
In the
ATM PVC Configuration
page, set VPI/VCI to
8/35 and click
Next
.
Step 4
In the
Connection Type
page, select PPP over
Ethernet (PPPoE) and set the Encapsulation Mode to
LLC/SNAP-BRIDGING, and then click
Next
.
Step 5
In the
PPP User name and Password
page, enter the
user name and password provided by your ISP.
IMPORTANT: Select Enable PPP IP extension.
Step 6
Click
Next
.
Step 7
In the
Enable IGMP Multicast and WAN Service
page,
keep the default settings and click
Next
.
Step 8
Confirm the network configuration and ensure that all
settings are consistent with the data provided by your
ISP. Then, click
Save
.
Step 9
Click
Save/Reboot
to apply the changes and reboot
the DSL Router.
Modify the LAN IP address in
LAN
in
Advanced Setup
.
After the PPPoE dial-up which is built in the DSL Router is
successful, the IP address 10.28.106.82 is obtained.
4.4.1.4 Adding a PPPoA PVC
This section describes the procedure for adding PVC 1/35
(PPPoA mode).
Click
Add
and the following page appears.
In this page, you can modify VPI/VCI, service category, and
QoS.