Appendix C
Introduction to Private Management Network and SSF Cable Tables
209
Pillar Data Systems Confidential
CU1
One of two control units (CUs). The following
describes the location of CU1:
•
For Pilots, CU1 is below CU0 (factory default).
•
For Slammers, CU1 is at the bottom of the
chassis.
•
For Bricks, CU1 is on the left when viewed from
the back of the chassis.
ETHn
Ethernet ports on Pilots and on the private
interconnect modules in Slammers. ETH ports are
numbered ETH0, ETH1, and ETH2. ETH ports are
located:
•
For Pilots, on the back of the control unit.
•
For Slammers, at the top of the private
interconnect module.
FCn
Fibre Channel ports on the back of Bricks and on
the private interconnect modules in Slammers.
FC ports are located:
•
For Slammers, at the bottom of the private
interconnect module and are numbered FC0,
FC1, and FC2.
•
For Bricks, in the RAID controller and are
numbered FC0, FC1, FC2, and FC3.
FSn
Fibre Channel switch ports at the bottom of the
private interconnect modules in Slammers.
FS ports are numbered FS0 through FS9.
SER
Serial port on Pilot CUs.
Table 79 Cable connection designations (continued)
Designation Definition
