Chapter 4
Replace Slammer Chassis
108
Pillar Data Systems Confidential
If the power up process is successful, the Axiom system
allows the Slammer replacement to join the system.
Important!
If Guided Maintenance encounters a problem
during power up, you must contact Technical Support to
continue Guided Maintenance for this FRU.
The cabling pattern that you follow to recable the Slammer
depends on whether your Axiom system has one or two
Slammers. For cabling information, refer to Table 80,
Important!
When you insert the FRUs into the Slammer
chassis in the following procedure, use care so that you do
not crush or bend the pins on the chassis midplane. If the
midplane is damaged, you must replace the entire chassis.
To insert a Slammer chassis:
1 Slide the chassis replacement onto the appropriate
mounting rails within the rack.
2 Secure the Slammer ears to the mounting rails with the
screws that you had removed earlier.
3 Follow the appropriate procedures in this guide to
remove the following FRUs, one at a time, from the old
chassis and to add them into their corresponding location
in the new chassis:
• The motherboard assembly for each control unit.
This assembly holds two fans, the battery, and the
motherboard tray for the control unit (CU).
• Two power supplies for each CU.
