OPW M00-051.00 FSC3000, Command-Line Configuration Manual

Page: 127 / 181

processed to Paymentech. RESET NOW? y
-- ISO Table reset to DEFAULT settings!
13. Force Bankcard Security Code
This feature allows the merchant/site owner to restrict fueling and/or meet requirements (for required fuel
training) before allowing credit cards to be processed at an unattended site. Specifically, many areas
throughout North America have restrictions on allowing the general public to fuel at an unattended fueling
location without being trained on the proper procedures to follow to avoid an accident or what to do in case of
an accident.
In order to support these requirements, the FSC supports a feature called “Bankcard Security Code” or
“Training Screens." The merchant/site owner enables a process that displays a fixed set of training screens
that the user must read and accept the responsibility of understanding the information presented before a
receipt can be printed providing the user a 5-digit security code specific to the card swiped that must then be
entered each time it’s presented at the terminal. If the presentation of training screens is not desired (or
allowed) the merchant can also manually train the card holder on proper operating procedures. Then,
entering the card holder's PIN (or last 8-digits) at the FSC, by selecting option 15 (“Create Registered Bank
Card Security Codes”) from the “SET NETWORK” command menu, will give the 5-digit security code directly
tied to the card intend for use.
When registered bankcard processing is enabled and the current time falls between the programmed
ON/OFF times, any ISO enabled bankcard that has “Force Registered Bank Card PIN prompt” set to “Yes”
will force the FSC3000
™
to prompt the user for the 5-digit Security Code assigned to their card.
If the user enters the correct Security Code, processing of the card to the network continues as normal. If not,
after three (3) failed attempts the system displays the “3 Bad Pins” message and returns to “Insert Card”
mode.
NOTE:
To change Security Codes on all bankcards use the “SET SECURITY” command to
change the values used for generating the code.
It is the merchant’s responsibility to confirm the acceptability of this feature with local codes
before enabling.
Enter option number or press [RETURN] to exit: 13
This feature is intended for use at UNATTENDED Fueling Locations.
Enabling this feature will cause all ISO table enabled
cards with the "Force PIN" option set, to prompt for
a Security Code assigned to the card number BY THIS Site Controller.
Enable Registered Bank Card PIN Prompting (Y/N)? Y
Bank Card PIN prompting ENABLED!
Present Training Screens if PIN is UNASSIGNED or 3 BAD ENTRIES (Y/N)? Y
Training Screens ENABLED!
Present BITMAP screens instead of TEXT when FIT500 is in use (Y/N)? Y
NOTE:
If no is entered, text only messages will displayed!
Doc. No.: M00-051.00 Rev.: 10
Page 127 of 181