OPW M00-051.00 FSC3000, Command-Line Configuration Manual

Page: 53 / 181

7.2 VIT (Vehicle Identification Terminal) – PetroLink™
When the FSC3000
™
is equipped with the PetroLink™ option the VIT and its position(s) will need to be
configured.
7.2.1 Install VIT x (VIT 1 to 4)
The configuration type and position(s) of each VIT must be defined to activate a specific PCT and position.
Type:
Install VIT # <ENTER>
Type 8 (Y/N)? Y (PetroLink uses only type 8 VITs)
7.2.2 Configure VIT # (# = 1 to 4)
The
Configure VIT #
command can be used to configure all positions on the specific VIT. If desired,
configure specific positions using the command “Configure VIT x Position x”.
7.2.3 Configure VIT # POS # (VIT 1 to 4 and POS 1 to 8)
Each VIT and its position must be configured to activate a specific PCT and Position.
Type:
Configure VIT # POS # <ENTER>
VIT x POSITION x
CONFIGURATION
|- Activate PCT x Position x
|- Authorize with Pump Handle: OFF
|- Maximum Disconnect Time (seconds): 5
|- Status Noise Threshold: 1
Enter new PCT: 1 (Defines which PCT will have a pump activated on)
Enter new position: 1 (Enter the position of the PCT to activate when VIU
detected)
Authorize with Handle ON (Y/N)?: N (Allows pump to turn on even if sensed on
immediately)
Enter Maximum Disconnect Time (seconds): 5 (Max time for VIT no longer senses
VIU)
Enter Status Noise Threshold: 1
Repeat the process to configure each VIT position.
7.2.4 Install VIT # POS # (VIT 1 to 4 and POS 1 to 8)
The
Install VIT # POS #
command indicates to the system that a VIT position will be used.
Repeat the process to install each configured position.
Doc. No.: M00-051.00 Rev.: 10
Page 53 of 181