2.5 Cold Start Procedure
Figure 2-1 FSC3000
™
Cold Start Procedure
To cold start the FSC3000™:
1.
Power
down
the
unit
by
unplugging
the
power
cord
on
the
rear
panel.
2.
Plug
the
power
cord
back
in
and
at
the
same
time,
push
and
hold
the
two
(2)
front
panel
buttons.
3.
A
“Beep”
will
sound.
4. Release the front panel buttons
5. The front panel display will show that the FSC has been cold started.
Make sure the system is operational.
IMPORTANT:
A cold start will reset the FSC3000 to factory default settings. All card records
and transaction data will be erased.
On the initial FSC3000
™
setup it is recommended that the distributor wait to issue the “Set Admin” & “System
Start” commands until the system has been fully configured and tested. Pump control testing can be done by
issuing the “SET PUMP ON” command. FIT functionality can be tested by swiping a card to receive the
“System Stopped…” message.
NOTE:
The “System Start” command must be issued before network testing can be
performed.
Doc. No.: M00-051.00 Rev.: 10
Page 21 of 181
Summary of Contents for M00-051.00 FSC3000
