7 of 135
Do not allow the device or cables to be exposed to water.
z
Doing so may result in electric shock, fire or failure of non-waterproof devices or cables.
If the device fails or is exposed to water (non-waterproof devices or parts), or an unusual
smell, smoke, or sparks are detected, immediately refrain from using the device and
contact OMRON or a sales representative for service and repair.
z
Continued use of the failed device may result in electric shock or fire.
Do not use damaged cables.
z
Continued use of the damaged cables may result in electric shock or fire.
Fail-safe measures must be taken by the customer to ensure safety in the event of
incorrect, missing, or abnormal signals caused by broken signal lines, momentary power
interruptions, or other causes.
Be sure that all the mounting screws, terminal screws, and cable connector screws are
tightened to the torque specified in the relevant manuals.
Incorrect tightening torque may result in malfunction.
Be sure that terminal blocks and connectors are connected in the specified direction with
the correct polarity. Not doing so may result in malfunction.
If the power supply for the I/O circuits is turned ON with the input and output
connectors reversed, the fuse of output transistor may be blown.
Do not apply voltages to the input terminals in excess of the rated input voltage. Excess
voltages may result in burning.
Do not apply voltages or connect loads to the output terminals in excess of the maximum
switching capacity. Excess voltage or loads may result in burning.
When transporting the Units, use special packing boxes. Be careful not to apply excessive
vibration or shock, or not to expose to water during transportation and not to drop the
product.
Do not install or keep the V750-BA50D04-SG(-MY) in the following locations:
-Locations subject to shock or vibration.
-Locations subject to condensation as the result of severe changes in temperature.
-Where the device may be exposed to water, oil, chemicals or organic solvents.
Do not use the system in an environment subject to flammable, explosive, or corrosive
gases.
Provide an enough space around the device for ventilation