20 of 135
1.4 Reader Installation
The following parts are provided with the reader:
Part
Quantity
Part Number
V750-Reader 1
V750-BA50D04-SG(-MY)
AC Adapter
1
-
I/O Port Connector
1
MC 1,5/10-STF-3,81
1.4.1 Install the Reader
You can place the reader on a shelf or mount it on a wall. A surface of the shelf or wall should be flat to fix the
reader securely.
To mount the reader on a wall:
1. Hold the reader in its four mounting location and mark the position of the mounting screws
2. Drill holes for the screws and install wall anchors if required. Be sure anchors must have enough strength
to fix the reader against vibration.
3. Hold the reader at the position on the mark and insert the M4x16 screws with spring washers and flat
washers, and tighten until almost flush with the wall. Two persons (one for hold the reader and the other for
tighten the screws) are required for this installation for the safety.
4. Tighten the screws securely.
5. Place the external power supply where it is not obstructed and fix it so that not to move by vibration and
tense DC cable. Do not bundle the cables with other signal or power lines.
IMPORTANT:
Be sure to remain within the rated voltage and current of the power cord and outlet.
Mechanical Loading
- Mounting of the equipment in the rack should be such that a hazardous condition is not
achieved due to uneven mechanical loading.
1.4.2 Install the Antennas
The antennas can be mounted directly to a variety of surfaces. Mounting surfaces should be flat to fix the
antenna securely.
To mount the reader on a wall :
Mounting holes