37
The following data can be transferred between the NT600M and the Support
Tool.
Data
Support Tool to NT600M
NT600M to Support Tool
Screen data
All screens or one screen
All screens or one screen
Character string table
YES
YES
Numeral table
YES
YES
Mark data
YES
YES
Display history data (in
order of frequency or in
order of occurrence)
None
YES
System Memory (Initial
screen after power-up)
YES
YES
Note
When using the EEPROM as a screen data memory, screens cannot be
transferred screen by screen from the Support Tool to the PT. The screen
data must be transferred in file units after initializing the memory.
3-4
Trial Operation
After screen data has been transferred, or after a screen data memory chip
has been installed (when EPROM is used), the following procedure can be
used to carry out a trial operation.
1, 2, 3...
1.
Connect the Host Interface Unit to the host. (Refer to the
Host Interface
Operation Manual
.)
2.
If the screen data memory is okay, then the PT will automatically go into
RUN Mode when it is powered up, and the RUN indicator on the front
panel will light.
3.
Check the host-to-PT communications by transmitting a screen-change
command from the host, and checking whether the screen is changed.
4.
Check the PT-to-host communications by transmitting to the host by
means of function keys, touch switches, and external inputs, and seeing
that they are all transmitting properly.
5.
If communications with the host cannot be executed properly, refer to
6-2-6 I/O Checks
.
Trial Operation
Section 3-4
Summary of Contents for NT600M Series
Page 1: ...NT600M Programmable Terminal Operation Manual Revised October 1997 ...
Page 2: ...iv ...
Page 4: ...vi ...
