!
33
To initialize the screen memory, for example, first access the System Menu
by simultaneously pressing the Buzzer Key, Up Key, and Down Key. Then
proceed as shown as shown in the following chart.
System Menu
Select “MAINTENANCE MODE.”
Select “Init. Screen.”
Initialize Screen Memory?
No
Yes
Refer to Section 6.
Select “Init. Memory.”
If you select yes, then memory will be initialized and all data used for displays
will be erased. After initialization, operation will begin in RUN Mode.
If you select no, then operation will begin in RUN Mode without initialization.
When entering RUN Mode after initialization, nothing will be displayed on the
screen and the Terminal will wait for a command from the host.
To initialize other data memory, return to the Maintenance Mode and follow
the same procedure.
Caution
Screen memory must be initialized before using a new PT. If the PT is used as
shipped from the factory without initialization, messages indicating errors in the
host will not be displayed properly.
Initialization
Section 3-2
Summary of Contents for NT600M Series
Page 1: ...NT600M Programmable Terminal Operation Manual Revised October 1997 ...
Page 2: ...iv ...
Page 4: ...vi ...
