24
2.
Insert the PT into the hole from the front of the panel.
3.
Use the accessory metal fittings and tool to fasten the PT to the panel
surface. Do not use a screwdriver. A screwdriver may damage the fit-
tings or the PT.
After setting the PT in the panel, secure it as shown below.
(1) First pass the plastic part of the fit-
ting through slot (a).
(2) Next, put the hook of the fitting into
slot (b) and pull so that the leg
catches in the PT case.
NT600M
Fitting
Plastic
(1)
(2)
(b)
(a)
NT600M
Accessory tool
(3) Turn the screw with the tool that
comes with the PT, and secure
the PT to the panel. There are six
places to be secured. When you
are finished, rotate the tool in the
inverse direction and remove it
from the screw.
4.
To remove the PT from the panel, use a flat-blade screwdriver.
--
6 panel installation fittings
Standard screwdriver
NT600M
Installing the NT600M PT in a Panel
Section 2-4
Summary of Contents for NT600M Series
Page 1: ...NT600M Programmable Terminal Operation Manual Revised October 1997 ...
Page 2: ...iv ...
Page 4: ...vi ...
