6 I/O Interface
6 - 52
Vision System FZ5 series Hardware Setup Manual (Z423)
• Connect the LAN cable with a straight or cross cable.
• Use an STP (shielded twisted-pair) cable of category 5, 5e, or higher. Applicable EtherNet/IP com-
munications cables and connectors vary depending on the used baud rate.
• For 100Base-TX and 10Base-T, use an STP (shielded twisted-pair) cable of category 5 or higher. You
can use either a straight or cross cable.
• For 1000Base-T, use an STP (shielded twisted-pair) cable (double shielding with aluminium tape and
braiding) of category 5e or higher.
• Electrical specifications: Conforming to IEEE 802.3 standards. Use RJ45 8-pin Modular Connector
(conforming to ISO 8877).
• When selecting a connector, confirm that it is applicable to the cable that will be used. Confirm the
following items: Conductor size, conductor type (solid wire or twisted wire), number of twisted pairs (2
or 4), outer diameter, etc.
10Base-T and 100Base-TX
1000Base-T
6-4-2
FH-L Series
Cable
I/O Connector
Pin Layout
Connector pin
Signal name
Abbr.
Signal direction
1
Transmission data +
TD +
Output
2
Transmission data -
TD -
Output
3
Reception data +
RD +
Input
4
Not used.
---
---
5
Not used.
---
---
6
Reception data -
RD -
Input
7
Not used.
---
---
8
Not used.
---
---
Connector pin
Signal name
Abbr.
Signal direction
1
Communication data DA +
BI_DA +
Input/output
2
Communication data DA -
BI_DA -
Input/output
3
Communication data DB +
BI_DB +
Input/output
4
Communication data DC +
BI_DC +
Input/output
5
Communication data DC -
BI_DC -
Input/output
6
Communication data DB -
BI_DB -
Input/output
7
Communication data DD +
BI_DD +
Input/output
8
Communication data DD -
BI_DD -
Input/output
