5 Setup and Wiring
5 - 14
Vision System FZ5 series Hardware Setup Manual (Z423)
Connect to the terminal block by using the terminal connector, male: FH-XCN-L, which is packaged with
Sensor Controller.
Use the wire of a suitable size (AWG 12 to 16) according to the current consumption. Keep the power
supply wires as short as possible: Max. 2m.
1
Insert the end of the signal line, electric wire, into the terminal block connector (male).
Tighten the three screws on the connector top to secure the wire.
Recommended tightening torque: 0.5 to 0.6 N
•
m
2
Insert the terminal block connector (male) into the terminal block connector (female) on the FH
Sensor Controller side.
3
Insert the power supply terminal connector (male) into the power supply terminal connector
(female) on the sensor controller side.
4
Secure the terminal block connector (male) by tightening the screws on the right and left sides
of it with a flathead screwdriver. Recommended tightening torque: 0.5 to 0.6 N
•
m
Connection of Terminal Block of FH-L Series
Power Terminal Con-
nector
Function
+
Connect to the DC output teV of 24 VDC.
-
Connect to the DC output terminal -V of 24 VDC.
Connect to the earth.
Terminal block connector (female)
Terminal block connector (male)
18.2
15.85
4.7
8.3
15
5.08
5.08
(Unit: mm)
